SOHC.co.uk Forums > CB750

dripping tap

(1/2) > >>

billy192:
my petrol tap is dripping even when off. not much but enough to drip out of the exhaust when starting up after a week.

is there any way to adjust/tighten ?
Billy

Bitsa (Ralph Wright - RIP):
Billy
Is yours screwed on to the tank by a big nut?If so you could try taking it to bits and clearing any shite that's lodged behind the tap lever.If no good replace it.
Cheers
Bitsa

Bryanj:
Billy thats a typical problem of not replacing the fibre washers under the heads of the two screws holding the tap to the tank, petrol comes down the threads and bypasses the on/off part so flooding out one or more carbs if the float needles are not perfect

K2-K6:
I'll not cover the advice already given but add that if you think you've had neat petrol accumilating in the cylinders when not in use, then you need to check the the engine oil is not diluted with it as it will run past the piston rings down the bore.......not good for any of the bearings.

Also there is a risk of bending conrods in extreme cases so make sure you're happy you've cured it.

billy192:
Mine has no screws for the fiberes it is quiet new


Sent from my iPhone using Tapatalk

Navigation

[0] Message Index

[#] Next page