SOHC.co.uk Forums > CB750
CB750 bearing shells
AshimotoK0:
--- Quote from: trigger6969 on August 06, 2014, 07:45:37 AM ---Ash, you are confusing me on what you think NOS means. NOS, stands for New Old Stock. So, Nos is new or are you on about secondhand shells? Secondhand sells are worth nothing or whatever someone is willing to pay.
--- End quote ---
NOS to me is New Old Stock as opposed to new bought from Honda for resale. i.e my 750K0 exhaust was new because DSS bought it from Honda and then shortly afterwards sold it to me. The gear lever they sold me was 'NOS' because it came from an ex-dealers inventory of stock bought in the 80's.
The shells I am looking at are not used they are NOS mostly in the Honda bags, I wouldn't dream of using secondhand shells (other than the unworn ones fitted to the original crank). There are a couple not in the bags but I have seen them and they look new.
Cheers ...AshD
Trigger:
OK Ash, we are a little clearer now. I would offer 3 to 5 each but, it is down to what he is willing to sell them for.
Where did you find those small screws and nuts? They fitted a treat to the button on the switch gear. Cheers for those Ash.
AshimotoK0:
Quote from: trigger6969 on Today at 08:36:30 am
OK Ash, we are a little clearer now. I would offer 3 to 5 each but, it is down to what he is willing to sell them for.
Where did you find those small screws and nuts? They fitted a treat to the button on the switch gear. Cheers for those Ash.
I think he is looking at 5.50 GBP each for the bagged ones and 3 GBP for the non bagged ones but I need to be quick as someone else is sniffing round them.
Screws ... I make a focusing mechanism for an add on to a scanning electron microscope for a company near Cambridge. It has M1.4, M1.6 and M2 screw on it. If you need any more M2 screws / nuts just shout you can have them for free!!
If you want to buy a large quantity here is the RS Components P/N 528-693 (screws) 248-4551 Full Nuts they are both A2 grade SS The nuts fit the 400/4 and others switch push button . The screws the same but also fit the 250/400/4 trip meter knob (not the 250K0 though 'cos it doesn't have a trip meter!)
The smaller than M2 screws we get from these people
http://www.microfastenings.com/Home.aspx
Cheers ...Ash
Trigger:
Ash, grab them before someone else does.
AshimotoK0:
--- Quote from: trigger6969 on August 06, 2014, 08:56:35 AM ---Ash, grab them before someone else does.
--- End quote ---
I will do and after I have measured my crank/looked at my big ends ::) I will offer any spares I have on here for what I pay for them plus post. This will be my one and only 750 restoration so I won't need any spares.
Cheers ... Ash
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version