SOHC.co.uk Forums > CB500/550
changing valves to different head
Trigger:
Electric drill? Bloody cowboys >:(
MikeM:
from what I can tell once you get a smooth ring on both faces your good to go ?
also does the part the valve slides into need to come out ? original head has new stem seals
valve guides ?
Johnwebley:
--- Quote from: Oddjob on August 16, 2014, 10:26:04 PM ---Speaking of that I've found my original Honda CB500/4 valve guide reamer. Not seen it for ages and it was hiding in my Snap On box. As I doubt very much whether I'll ever use this again I may donate it to someone on the understanding they will lend it to whoever needs it.
--- End quote ---
Oddjob,
it might be an idea to have a separate thread, "Special tools for loan"
the user pays postage ,and returns after use
perfect for smaller items
ka-ja:
Hi,
The electric drill reference was being sarcastic, although I have known one to be used. Slow and steady and not too much pressure, lifting the valve off its seat for a 1/2 turn now and then during grinding is the only way!
Bryanj:
Oddjob, i would take over the reamer if you wanted, i have several heads if i can ever afford the guides!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version