SOHC.co.uk Forums > CB350/400

Seat newly stencilled

(1/4) > >>

Drew400:
Got the stencil from Piki in Spain, via this forum.

Looks pretty good to me (along with my newly shod wheels). All I need now is a bike to put them on (with an engine that's got some bearings [see other post])!

Cheers,

D.

Clem2112:
Looks good. Did you use Brillo leather/vinyl spray ?

Hardest part was deciding the height at which to position it I thought !

AshimotoK0:
DSS should be selling Yamiya seat blank, no logo then we could use a stencil to put the HONDA logo on ourselves.

Cheers ...Ash

Drew400:
Thanks all,

There were traces of my old logo remaining which gave me a hint about positioing. I then cleaned that off with WD40 and a rag and washed the area with soap and water before going through the stencil process.

I have no doubt that, depending upon my use of the bike when it's eventually rebuilt, it'll wear off again, but it's pretty easy to do again if it came to that eventuality.

Cheers,

D.

Nurse Julie:
Hi Drew

Have you got a web address or contact details for Piki, I'm looking for seat logo for my 400/4. Iv'e only got the DA letters left on mine, looks bloody stupid.

Ta
Julie

Navigation

[0] Message Index

[#] Next page