SOHC.co.uk Forums > CB500/550
Is this a genuine clutch lifter push rod mod or what...
Bryanj:
Don't think the dome has to be a perfect match, just a half round as the lifter will spin on a point contact. Link below is to a yank selling an old stock modification kit so you can see what is in it, the bulletin should be on the US board somewhere.
http://www.ebay.co.uk/itm/251624595959?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649#ht_1649wt_721
Trigger:
Nice bit of information Bryan, Cheers. Have changed all the parts except the push rod. Why does he have clutch case in the picture? I looked at the case but, could not find any difference.
simonster:
I have re examined my push rod. It has an alloy sheath over a steel inner. The alloy extends the entire length bar one inch from the domed end which then steps down in diamter by approx 0.3mm to 7.5 mm to perfectly fit the lifter mushrrom. Could be this domed section is the same on the K0 model!?
Trigger:
The rod i took out the K0 is some sort of Black steel. Also have a alloy push rod that has the same fitment to the mushroom.
simonster:
Thanks for the info. I'm going to buy a 7.8 mm steel rod and step it to fit the lifter mushroom unless anyone can give a more accurate diameter size over my measurement?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version