SOHC.co.uk Forums > CB350/400

Clock Sealing Bands

<< < (3/3)

Trigger:
If you cut it, you will always see the join. I just use a piston ring clamp and a small pin hammer to panel beat it back into place.

AshimotoK0:
I got a micro spot welder for a job I am doing and am going  to try on cut bands but not had time yet. I was going to Dremel the outside of the two clock body 'halves' slightly to make up for the cut gap.

Cheers ... AshD

Navigation

[0] Message Index

[*] Previous page