SOHC.co.uk Forums > CB350/400
Fuel tubes
Bodd:
--- Quote from: Dan on September 02, 2014, 05:59:48 PM ---If you're keeping the original filter box you could route the hose to a catch tank with a filtered vent hidden within said box. May need a longer hose but that would make periodical emptying of the catch tank easier. Looking at your RD and CB blogs I would imagine you could do this quite easily and there's no risk of oil mist getting on the rear tyre.
--- End quote ---
Good plan 8)
bike-pusher:
--- Quote from: Bodd on September 02, 2014, 12:17:39 PM ---I was thinking of refitting the chamber breather and attaching it to that but I thought it might be spraying oil mist into the empty filter box, preferable to spraying it on the back tyre but still not good, I might just get a filter and use the proper route and connection.
--- End quote ---
The rocker box breather is simply vented to atmosphere - there's a circular clip for it at the bottom of the frame.
Bodd:
--- Quote from: bike-pusher on September 02, 2014, 09:19:02 PM ---
The rocker box breather is simply vented to atmosphere - there's a circular clip for it at the bottom of the frame.
--- End quote ---
I don't think it is, it goes to the chamber breather connected to the bottom of the air box where clip number 1 is shown in the picture below, the drain tube number 27 goes to the bottom of the frame.
[ Guests cannot view attachments ]
bike-pusher:
Sorry, yes, you're right. Brain fart.
Lobo:
Hi again Bodd,
This is what I was looking for.... The CB750 K6 breather routing.
Cheers,
Simon
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version