SOHC.co.uk Forums > CB350/400
Fuel tubes
Bodd:
I thought it was in two separate pieces like in the drawing below but after stripping it down I found it's not, it's one solid piece with 2 O rings on each end ( it's a long time since I rebuilt the carbs), I've changed the O rings for some new ones and now there is quite a bit more resistance when I move it.
[ Guests cannot view attachments ]
Drew400:
Can I slightly hi-jack your thread by asking if the piece shown as no. 108 in your diagram is designed to simply act as a balance between carbs (i.e. sharing air/fuel vapour rather than liquid fuel)?
Thank you, D.
Bodd:
--- Quote from: Drew400 on August 26, 2014, 03:11:05 PM ---Can I slightly hi-jack your thread by asking if the piece shown as no. 108 in your diagram is designed to simply act as a balance between carbs (i.e. sharing air/fuel vapour rather than liquid fuel)?
Thank you, D.
--- End quote ---
In the parts list it's called "tube, fuel, 2.5 x 16", I don't think it carries liquid fuel as the part circled below does that.
[ Guests cannot view attachments ]
Drew400:
Me too thanks.
I'm doing a similar job now on my carbs. I think I finished putting them back together yesterday and will one day put them on an engine.. that's the next big sub-project in my money pit heaven!
Cheers, D.
Bodd:
Not a fuel tube but not worth starting another thread, as I am using K&N pod filters where do I route the breather tube (331 in the picture) ? I still have the filter box on the bike but there won't be a filter in it.
[ Guests cannot view attachments ]
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version