SOHC.co.uk Forums > CB500/550

It has arrived!

<< < (14/25) > >>

Trigger:
Number 1, which is the 4x 0'rings go on to the T pipe>>>  http://www.cmsnl.com/honda-cb550f2-super-sport-550-four-1977-england_model17121/partslist/E17-1.html#res

JustcallmeMrT:
Ok, I see what you're talking about.  So if I remove that cast plate I can access those?  And where would I get replacements?  Would they be part of the carb rebuild kit I just got from DSS?

Trigger:
Should be in the kit but, i have never got one from DSS. I always get from Japan or the Dutch carb guru.
Yes, if you remove those 8 screws the cast plate (as you have called it) will swing up and all the carb body's will be lose enough to change the O'rings on the T pipe's.
It also maybe worth paying someone to sonic clean the bank in one piece.   

JustcallmeMrT:

--- Quote from: trigger6969 on September 14, 2014, 12:20:16 AM ---Should be in the kit but, i have never got one from DSS. I always get from Japan or the Dutch carb guru.
Yes, if you remove those 8 screws the cast plate (as you have called it) will swing up and all the carb body's will be lose enough to change the O'rings on the T pipe's.
It also maybe worth paying someone to sonic clean the bank in one piece.

--- End quote ---
What about the short rubber tubes running between the carbs - do those need replacing?

Trigger:
I think you are on about the vent tubes. You just cut a bit of hose for those.

Navigation

[0] Message Index

[#] Next page

[*] Previous page