SOHC.co.uk Forums > CB500/550

It has arrived!

<< < (16/25) > >>

Trigger:
In your last picture you can see the air screw. It is too the right of the T pipe if you look at the picture. It has a brass head and when you remove it there will be or should be a spring. One per carb.

JustcallmeMrT:

--- Quote from: trigger6969 on September 14, 2014, 07:43:40 PM ---In your last picture you can see the air screw. It is too the right of the T pipe if you look at the picture. It has a brass head and when you remove it there will be or should be a spring. One per carb.

--- End quote ---
Got it.  So, I should remove the air screws, the T pipes and those tubes from between the carbs, anything else?

Trigger:
Do you have the brass tubes out??? They will have little holes down the sides.

JustcallmeMrT:

--- Quote from: trigger6969 on September 14, 2014, 07:57:12 PM ---Do you have the brass tubes out??? They will have little holes down the sides.

--- End quote ---
Yep, got them out.

Trigger:
The brass screws from the float bowls??? If that is it they should be ready for a dip. Take the bank of carbs, the bowls, the tops and everything you have removed to be cleaned. Then all you have to do is put them back together. Polish the bowls and tops. And set the float height which is 22mm on those.

Navigation

[0] Message Index

[#] Next page

[*] Previous page