SOHC.co.uk Forums > CB500/550
It has arrived!
JustcallmeMrT:
--- Quote from: trigger6969 on September 14, 2014, 08:03:02 PM ---The brass screws from the float bowls??? If that is it they should be ready for a dip. Take the bank of carbs, the bowls, the tops and everything you have removed to be cleaned. Then all you have to do is put them back together. Polish the bowls and tops. And set the float height which is 22mm on those.
--- End quote ---
Thanks Trigger, you've been a huge help!
Trigger:
I should of said, send me the carbs with the fitting kit and £100 and i will do the rest ;)
JustcallmeMrT:
--- Quote from: trigger6969 on September 13, 2014, 09:53:45 PM ---I would not advise someone to take these apart unless they know what they are getting into. There are so, so many little parts to them. But, you can get them apart to change the 0'rings in the T pipes by taking the 8 big cross head screws out of the big alloy rail that holds them together.
--- End quote ---
Another carb question. Measuring the o-rings on the T pipe, looks like they're 12mm OD, 8mm ID and 2mm thick. Is this right? Would a set of nitrile rings of this size be the correct replacement?
Trigger:
You should of got the O'rings in the carb kit. Are you saying that DSS did not put them in???
JustcallmeMrT:
As far as I can see, they are not there... All the bits for each individual carb, but not for the T - tubes between them.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version