SOHC.co.uk Forums > CB350/400
New in
Bryanj:
When doing a PDI you barely had time to scratch your arse never mind outthink mr Honda mate!!
tom400f:
Ah OK - the original manual must be right. That said, I got my bike when it had only 1800 miles on it. I suspect it was like that from the factory. May be I should move it ::)
Clem2112:
I can see the sense for the cable guide ring being secured horizontally if the cable is re-routed over the coils to give a bigger arc.
Mr Honda liked to put all the cables through that front chromed clip which seems to confirm the position of the rear guide on the engine breather cover - the guide's rubber sleeve and clearance from the engine ensures cable survival I would think. The coils get a tougher time !
bike-pusher:
I've only ever seen that cable loop attached to the top of the cam cover, at least on bikes that I know have never been molested.
Woodside:
Just got in from work and after reading this discussion. Apart from thinking I should have called this thread "where does the clutch cable bracket go".. I had a good look at mine and then had a really good look at the diagram again and have blown it right up.....
First off it looks pretty at home on the coil bracket.
But more interestingly after blowing the diagram up to doesnt really apearr to be fixed to anything...so perhaps this is where the confusion is ...that it was completely open to interpretation ???
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version