SOHC.co.uk Forums > CB750

Starter clutch

(1/2) > >>

sand5858:
Hello there.
Is there anyone here who has tried to change the starter clutch on a CB750
I think that the Phillips screws that hold the hub in the clutch is very difficult to loosen.
Afterwards, the flywheel is mounted on the crankshaft and tighten with torque and I think this is also a challenge - something to have a friend on the motorcycle while I mount the flywheel.

All proposals received.
Regards
Tony

Bryanj:
Impact driver for the screws and you will be suprised how easy it is to do up the bolt

bike-pusher:
Is this a job that can done with the engine in the frame?  And if so, what needs removing to get at the clutch?

Bryanj:
750 starter clutch is on the back of the generator Rotor so side cover off, undo bolt('Kin tight), use proper screw in puller to remove rotor---replace all necessary bits and reassemble

Bitsa (Ralph Wright - RIP):
Spot on Bryan not really a hard job too do
Cheers
Bitsa

Navigation

[0] Message Index

[#] Next page