SOHC.co.uk Forums > CB350/400

Switchgear Wiring Route

(1/3) > >>

Lynx:
Hi all,
I fitted my newly chromed handlebar today. This is a genuine one with the holes in for the switch wires. The one it is replacing is a pattern without the holes. So I routed the wires inside the bar OK but when I came to fit the switchgear, I found it a bit awkward. I thought the wires would route from inside the switch block straight into the handlebar holes but they didn't want to do that. Have a look at the photos attached and see if you think that is right.
Cheers

Bitsa (Ralph Wright - RIP):
Lynx
They go on further than that you do not see any wiring and also there should be a pin that locates in the handelbars
Cheers
Bitsa

Lynx:
Ah crap! I was afraid you were going to say that. That means the metal on the left and right blocks has been broken out to allow the cables to be routed on the outside of the bar. The pins are missing too .

Bitsa (Ralph Wright - RIP):
Lynx
All is not lost you can use a decent sized rivet for the pin providing the hole is there in the bottom half and once you have it located you can patch the hole maybe with jb weld or similar?and paint it only you would know whats been done
Cheers
Bitsa

Lynx:
Yes that'll be do-able. I've even got spares but they've been butchered too!

Navigation

[0] Message Index

[#] Next page