Other Stuff > What is it?
master cylinder
Trigger:
Bitsa, you can use a drill to find the ID bore. ie, a 12mm drill bit ;)
Bitsa (Ralph Wright - RIP):
Yeah Ok nice idea growing old sucks never crossed my mind to think that cheers Trig
Bitsa
Trigger:
On these masters it should be 12mm to 14mm off the top of my head.
Sent from a £30 phone
Bitsa (Ralph Wright - RIP):
Fantastic Trig you never fail to amaze me but the biggest drill bit I have is 11mm.Did a rough measure with a tape I know not good enough and came out 13mm.Guess I am knackered after cutting down trees and bushes will give it ago again in the morning
Cheers
Bitsa
Bryanj:
If its 14mm the normal K series seal kit will fit, just some of the later ones did not fit the check valve at the end---gawd knows why
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version