SOHC.co.uk Forums > CB350/400
Winter Work
Nurse Julie:
--- Quote from: Lynx on November 25, 2014, 07:06:32 PM ---Can you get hold of a Vernier Caliper to measure one?
--- End quote ---
Bitsa used to have a Vernier, his last relevant post said that if he ever found it, he would nail it to the floor. Did you ever findi it Bitsa? ;D ;D
Bitsa (Ralph Wright - RIP):
Julie
No I bloody well havent.Looks like I will have to buy another one damn shame it was a good un.It probably is now in the local tip in a box of rubbish
Cheers
Ralph
ka-ja:
Hi,
Standard bore is 51mm, best to measure that, but with a piston at 50.8mm, it looks like standard sizes.
hondatri:
I brought Piston and Rib=ngs to my Friendly Motorcycle Guru Who confirmed it as Standard he said no marks standard only marked when oversize, Order has now been sent off (Christmas fund empty) Does anyone know where I can get a Standard Camchain screw The previous owner just put in an ordinary 6mm bolt with no lock nut.. Thanks Guys for all the help and info as a guy once said I WILL BE BACK. I will keep forum posted on progress
ka-ja:
Hi,
If you are not too bothered about originality try
http://www.ebay.co.uk/itm/HONDA-CB400-FOUR-STAINLESS-STEEL-CAM-CHAIN-ADJUSTMENT-BOLT-LOCKNUT-/281486100722?pt=UK_Motorcycle_Parts_13&hash=item4189e108f2
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version