SOHC.co.uk Forums > CB500/550

identifying handlebars

(1/2) > >>

wolfheze:
Hi, I am trying to establish if a pair of handlebars that came with my k2 are original North American spec. They measure 30 inches across with a rise of around 8 inches, they have an oval hole in the centre and one at each end for routing the wiring and are capped off at each end with plastic inserts. Any ideas?
Thank you.

Bryanj:
With that rise they definitely aint UK spec

Trigger:

--- Quote from: wolfheze on October 27, 2014, 07:25:18 AM ---Hi, I am trying to establish if a pair of handlebars that came with my k2 are original North American spec. They measure 30 inches across with a rise of around 8 inches, they have an oval hole in the centre and one at each end for routing the wiring and are capped off at each end with plastic inserts. Any ideas?
Thank you.

--- End quote ---
A little confused here. You have this post under 500/550 but, speak of a K2 ?

wolfheze:
Did they not make a 550 k2?

wolfheze:
The rise sounds more than it is. From the first to the second bend is around 5 inches, 8 inches is from the centre section to the ends

Navigation

[0] Message Index

[#] Next page