SOHC.co.uk Forums > Project Board
CB750F1 Project
martin_uk:
Frame stripped ready for blast and powder cost.
2014_0502cb750B40053 by nitram2010, on Flickr
2014_0502cb750B40057 by nitram2010, on Flickr
modified rh engine mounting before and after- makes it easier to fit engine as doesnt catch.
2014_0502cb750B40041 by nitram2010, on Flickr
2014_0502cb750B40049 by nitram2010, on Flickr
back from powder coat
2014_0519eng0017 by nitram2010, on Flickr
UK Pete:
Is that an import frame martin, way too clean for a UK one,
nothing better than a freshly coated frame
pete
martin_uk:
--- Quote from: UK Pete on November 18, 2014, 10:16:55 PM ---Is that an import frame martin, way too clean for a UK one,
nothing better than a freshly coated frame
pete
--- End quote ---
Its Uk, but picture looks better than reality, as lots of rusty areas but nothing too bad.
Nice to start with a fresh frame even if it takes ages to clean out all the threads ;D
Spitfire:
I remember when my frame looked like that, I was too scared to touch it !
Cheers
Dennis
martin_uk:
Rear wheel and brakes installed.
Original caliper powder coated, found the brake pad cover on CSMNL
2014_0716brakes0020 by nitram2010, on Flickr
You can also see the braided stainless brake hose with black cover I used as could not get OE
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version