SOHC.co.uk Forums > CB500/550

Bushes - I need a "how to" guide

(1/6) > >>

JustcallmeMrT:



Hi all, I'm prepping my swingarm for powder coat, and as this is my first time at any of this, wondering how I get these shock mount bushes and front bushes out of this thing?  Hammer time?

paul G:
Mr T,

On the shocker bushes I use a socket slightly bigger than the hole with a threaded bar nut and a washer and just screw them out. If you youtube it you will see how to do it.
Watch out for the tapered edge when you are reinstalling and it is just the reverse process.
On the swing arm bushes I did mine with a blind bush/bearing puller but you can drift them out be careful with the bronze type. If you are putting new in as I did then it doesn't really matter how you get them out.

Regards,

Ewan 500 K1:
some photos for shocker bush removal here T:  http://www.sohc.co.uk/index.php/topic,4120.90.html

JustcallmeMrT:

--- Quote from: Oddjob on December 17, 2014, 02:07:43 PM ---Both can be a little tricky IF they've been in a long time.

Shock bushes, using a socket normally works, however they can sometimes be sort of bonded into position and the socket will just cut through the rubber bush leaving the outer metal casing behind. If that happens a junior hacksaw can be used to cut a line in the casing until the swinging arm is met, the casing will then contract and is easy to remove.

The inner steel part on the swinging arm bush in the pic is removable, pull that out and your left with 2 sort of hard nylon bushes, same hacksaw trick can be used and they can tend to break up if you try and push them out with a long screwdriver or similar from the other side. I tended to use the hacksaw trick and it was quite easy to cut through, Honda do a nice little bearing puller for the CB1300 but at around £50 to buy it's not really a good investment unless you plan to use it a lot. I'm sure there are bearing pullers very similar for a lot less, depends if your on a budget and just want to get them out on the cheap.

--- End quote ---
Oddjob, how do I remove the inner steel piece in the swingarm bush pic?  Sorry for such basic questions... feeling pretty new here.

Trigger:
You remove the pressed in bush by using a hacksaw blade. Cut down the bush until through, then cut another 10 mm away from the first. The 10mm bit of bush should come out by lifting it with a small screw driver. The rest of the bush will be easier to fold in on it self.

Just looked at the picture and this bush looks thicker than the standard type.

Navigation

[0] Message Index

[#] Next page