SOHC.co.uk Forums > CB350/400

Wiring

(1/4) > >>

hondatri:
    My Son was looking at my bike and saw an overheated wire Red/White under the left hand panel  it and a Red wire going into a 2 pin connector. He cut it off but did not record where they went. I had a look and found the previous owner had fitted a spade fuse and the red wire was going to it then off to the  Battery But I dont know where he cut the Red/White from. The wiring Diagram shows these 2 wires coming from the battery,If I connect both wires to the Battery and turn on Ign  nothing happened If I connect the red only I get the Oil and Neutral lights on. Can someone look at their bike to see where the Red /Red white wires goes.The 6 pin connector does not have the 2 red wires on tn the bike side of fuse holder(Probably the 2 going to the Spade Fuse. But where does the Red and Red/White wires go..

Nurse Julie:
Im looking at mine and can't see a red or white wire together anywhere. The only red is going in and out of a 6 pin connector coming from fuse box. Probably not much help i'm afraid

Nurse Julie:
I'm telling porkies, there are 2 reds coming from fuse box in to 6 pin connector

Bodd:
Red/white to rectifier and red to ignition

[ Guests cannot view attachments ]

Edit
The red/white wire goes to the rectifier connecting block which is wired like this.
[ Guests cannot view attachments ]

Lobo:
....just a thought Hondatri... little point in repairing the loom if the original fault not found / fixed?

A UK spec diagram Bodd!, hard to find. But where are the fuses for the Head & Tail lamp circuits?

Simon

Navigation

[0] Message Index

[#] Next page