SOHC.co.uk Forums > CB750
K1 rev counter
Trigger:
--- Quote from: dieffe on January 22, 2015, 12:05:59 AM ---You lot are good, I'll give you that. 8)
--- End quote ---
Only Good ? ;D ;D ;D
dieffe:
Me again,
I have managed to modify the later rev counter that came on the K1 to be like the earlier one. I got some new clock faces and fitted a pair of bulb holders, made some tubes to shroud them and wired them up.
It seems to have worked out fine and there is no light leaking out of or into the warning lights.
Well happy. :)
dieffe:
After finding out that the oil pressure switch was knackered and spending ages trying to figure out where I had gone wrong in modifying the later rev counter >:( I have finally got it fitted and working.
It was a bit of a headache but worth it in the end.
Hoorah!!!
JamesH:
Nice work - what did you use to make the light tube shrouds?
dieffe:
I made the tubes out of some copper pipe with the ends folded over so I could rivet them in, and at the top used small pieces of rubber tube similar to what was in the speedo.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version