SOHC.co.uk Forums > CB350/400

D/S repro exhaust

<< < (2/2)

Frisky:
Hi Myford,

If it is the DSS own brand (Motad) exhaust, then you don't need any clamps on the downpipes to collector box at all. They are simply push fit and you should notice that there are no "slits" in the collector box for tightening up.

Only the No1 cylinder pipe has a clamp on the collector box and that is all that holds the system together at the front end and the silencer clamp holds it together at the rear.

Depending your silencer, you will need a fibre washer and clamp on that of course

Hope this helps

Frisky

Chris400F:
Hi Myford,

I'll go along with the previous two posts - there are no seals or clamps where the pipes enter the collector box.
There is a seal and clamp at the other end of the collector, where the silencer fits.
I liaised with DSS when I bought my exhaust, to make sure I got all the right bits. I made a list of what I thought I needed,
the only thing I'd missed was the stand stop rubber (not in DSS parts list).
Slightly annoyingly I still had to buy bolts to fit the silencer to the new bracket I also bought, but you can't have everything!

Chris

Myford:
Thanks for the advice guys.
I've modified my order this morning to suit. Saved a bit on clamps!
Terry

Navigation

[0] Message Index

[*] Previous page