SOHC.co.uk Forums > Project Board
f2cafe racer
yozzer74:
He did say he had skimmed a lot off it .I will do that thanks
UK Pete:
Yes as bryan says do it dry and measure, i would personally make them slightly undersize to avoid any problem
pete
yozzer74:
Will do .Just had my parts delivered from David silver's and there's one o ring missing not happy.
yozzer74:
Well I've checked the clearance and the gap was quite big so I've filed them down so there flush with the barrels .What is the purpose of these anyway.are they just to keep the rubber seals in place .if that's the case I'm sure it will be ok .being flush .
K2-K6:
Engineering dowells to position the head correctly on the barrels, likewise the barells to the crankcase has some more so the whole assembly aligns. The cam would also be parallel to the crank too. You may need to get some more if they don't locate the two components.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version