SOHC.co.uk Forums > Project Board
f2cafe racer
JustcallmeMrT:
The cable is soldered inside the case of the starter motor. I extended mine by crimping it into a butt - end connector then soldering and shrink wrapping it.
yozzer74:
Does it work ok
mike the bike:
There's a lot of current going through that cable so any joining has got to be well made otherwise it will overheat.
yozzer74:
How many amps would it need to be .
JustcallmeMrT:
--- Quote from: yozzer74 on January 29, 2016, 01:33:29 PM ---Does it work ok
--- End quote ---
Can't say as of yet, haven't had the chance to try it. I'm hoping to use the kickstart most of the time so should see minimal use.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version