SOHC.co.uk Forums > Project Board
f2cafe racer
yozzer74:
Thanks I will give it a try
yozzer74:
I've disconnected the blue and yellow wire from the points put card in between points now how do I test for continuity
K2-K6:
Have you got a volt meter that beeps when you connect the two probes together?
I so you put one probe onto one of the wires to the points and the other on onto the points mounting plate and you should have no connection\beep.
The status you are looking for with the card in place is for no electrical connect through the points to earth, if it tracks through then you are looking at a fault somewhere in that system you've checked.
yozzer74:
Yeah I have one I will go out and give it a try cheers
yozzer74:
Ok so I've done that test I don't get a beep at all with card in or out when I touch the back plate only time I get a beep is when I touch number 2&3 points
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version