SOHC.co.uk Forums > CB500/550

Does F2 need top yoke spacer D-washers

<< < (2/2)

JustcallmeMrT:

--- Quote from: Trigger on February 22, 2015, 06:34:52 PM ---D washers on the F1 top yoke but, not the F2. Not sure if it is a different alloy but, are you sure it is a F2 yoke is the question.

--- End quote ---
On this bike I'd be a fool to say I was sure of anything.  I think it was a frankenbike before I ever got it... tipped off by the GSXR indicators.

JustcallmeMrT:

--- Quote from: Oddjob on February 23, 2015, 02:19:02 AM ---Simple to test. Can an 8mm bolt go down the tube clamp hole, if so it's a 550F1 if not it's a 550F2. The F2 used 7mm with 10mm heads, the F1 used 8mm with 12mm heads, because the hole is thinner it left more alloy so it's less prone to breakage than the earlier version.

--- End quote ---
Perfect, will take a look.  Thanks!

Navigation

[0] Message Index

[*] Previous page