SOHC.co.uk Forums > CB750

K1 speedo

(1/3) > >>

dieffe:
Me again, I knew I would have a shed load of questions.
When I took the clocks off the K1 I noticed that the speedo had something rattling around inside. I thought it might be a loose bulb but when I stripped it , I am changing the face, I found two bracket looking parts floating around and I cannot figure out where they came from, I am guessing some form of light shield or reflector even.



They are on the right in the picture.

Has anyone any ideas?

Green1:
I'm sure they were tacked on the back plate either side of the odo I assume there to stop the face distorting

Mick 

dieffe:
Thanks Mick, but they are about 5mm too short for that and there's no sign of any tack weld or glue or anything.

Trigger:
If you look at the clock back plate you will see the other bit to the bulb shades. It will have 2 rivets with a cross pattern on them. These snap due to vibration on the fold.

Bitsa (Ralph Wright - RIP):
Remember seeing something like that on later clocks they were in front off the bulbs I thought they were for reflecting the bulbs to light up the whole gauage maybe wrong dunno.
Cheers
Bitsa

Navigation

[0] Message Index

[#] Next page