SOHC.co.uk Forums > CB350/400

Tappet Covers

<< < (2/3) > >>

Trigger:

--- Quote from: Johnwebley on February 25, 2015, 08:49:48 PM --- I recently bought a couple of caps for my 500 from DSS,I got the pattern ones,turns out they are slightly deeper,
when I removed one to check the tappet,I noticed a mark were the rocker had been hitting it,

BTW,they are damn expensive !!!

--- End quote ---

I know the ones John, Bloody things. Where did the alloy that the arm knocked off the tappet cover go ? That was my question to one of DSS bods.

mike the bike:
I use a 17mm impact socket to remove them, a hexagonal socket not a bi hex.

Johnwebley:

--- Quote from: Trigger on February 25, 2015, 08:58:00 PM ---
--- Quote from: Johnwebley on February 25, 2015, 08:49:48 PM --- I recently bought a couple of caps for my 500 from DSS,I got the pattern ones,turns out they are slightly deeper,
when I removed one to check the tappet,I noticed a mark were the rocker had been hitting it,

BTW,they are damn expensive !!!

--- End quote ---

I know the ones John, Bloody things. Where did the alloy that the arm knocked off the tappet cover go ? That was my question to one of DSS bods.

--- End quote ---



 I am fairly sure nothing broke off,just a crease were the rocker hit it

Nurse Julie:
I must have been very, very lucky when I took mine off, had absolutly no problems at all. Good thing to by the sounds of it  ;D ;D ;D

Drew400:
Hi Andy, I struggled slightly, but clearly not as much as you.

I replaced a few c/o DSS after burring their nut edges. If they're any use to you, PM me and I'll send them over.

Cheers,

D.

Navigation

[0] Message Index

[#] Next page

[*] Previous page