General > Out & About
out and about 2015
Johnwebley:
--- Quote from: Bitsa on April 14, 2015, 09:20:07 AM ---John
Lots of photos please ;D
Cheers
Bitsa
--- End quote ---
home early,got about 2/3rds of the way and lost all electrics,turns out a solder joint/wire fell off the back of the ignition switch,managed
to make a circuit using a safety pin pushed through two wires,and came home,
so no pics,no BBQ,and no burgers,
will need to check the joints on all 4 cables,
the switch is only just over 12 months old,really annoying
Lynx:
Oh dear. Good luck with that. That's about the 4th time I've been expecting to meet you John but we're never at the same meets. It was heaving but cold. Took one photo which is too big at the moment.
Bitsa (Ralph Wright - RIP):
Shite John thats bad news.Never mind hope your bike is sorted now. ;)
Cheers
Bitsa
Johnwebley:
--- Quote from: Bitsa on April 16, 2015, 08:58:29 AM ---Shite John thats bad news.Never mind hope your bike is sorted now. ;)
Cheers
Bitsa
--- End quote ---
all sorted,I even re-soldered the other wires incase they were "dry" joints or weak,
this was after a great 150 mile ride around mid-wales a week earlier,
fingers crossed,every thing seems ok now,so looking forwards to next wednesday evening -))))
royhall:
Used a few Cruzinimage kits now and I would say that if you throw away the float valves they are 100%. Everytime I use the float valves I cannot stop the leaks. And its not just one carb, they take it in tuns to empty your tank. I use the kits and pay for genuine Honda valves. Seems to work.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version