SOHC.co.uk Forums > CB750

K1 carb question

<< < (2/3) > >>

dieffe:
Thank you for that, I see now why they don't appear on any of the pictures I have been looking at.
Next obvious question, does it matter that the carbs bodies have been mixed up on the rail or do I need to take them back off and strip them?

JamesH:
Technically you could get away with it, assuming the other bodies are connected correctly. Personally I'd rebuild and get it right...

dieffe:
You're right, it's probably best to have them right and it would mean I can give them a bit of a clean up while I'm at it.
Ah well, one step forward, two steps back.  ;D

JamesH:
Well when you get them off the bike, post some pictures up here and we can advise. James

dieffe:
Cheers James, I have taken them off the rail and realised that the choke lever needed moving to the other carb. Not too bad a job once you get the tiny little split pins out!!!



I hope that this is now correct, all I need to do now is chuck them back together. I didn't realise before that all the air screws were in the wrong place and the bowl drain plugs were all facing inwards. That should have given me a clue.  ::)

Beats me why this has happened, why would anyone change them round?

Navigation

[0] Message Index

[#] Next page

[*] Previous page