SOHC.co.uk Forums > CB350/400

400/4 missing breather chamber

(1/2) > >>

Harold 400/4:
After some advice please.
Discovered my bike is missing the metal grille that sits at the bottom of the air filter box. On looking into this, I found the whole breather chamber assembly beneath the air filter is also missing.
Am I right in thinking the hose from the breather cover on the top of the engine is supposed to go into the breather assembly under the air filter?? At the moment, it runs right down by the centre stand.
Bike seems to run ok, but would the absence of a breather unit affect running??
Any comments much appreciated.
Cheers
Harold

hairygit:
I've never had an issue running my 750F1 without it fitted. It's supposed to recycle any unburnt hydrocarbons that blow past the rings back through the intake system. It was only put there to satisfy American emissions regulations of the time.

paul G:
Harold,

Yes the breather pipe fits onto a plastic moulding at the bottom of the air filter assembly.
It also has another pipe which acts as a drain.
Don't think it will affect the running of the bike just the emissions.

Harold 400/4:
Thanks for that. Bike does run well, so sounds like it's not too much of an issue.
Cheers
Harold

mike the bike:
I binned mine ages ago.   The gases from the breather box used to mess up the air filter

Navigation

[0] Message Index

[#] Next page