SOHC.co.uk Forums > CB750
Tank badges
Sparrow1:
Wow! Thanks Ash.😊
Nige.
AshimotoK0:
Attached results of the 'experiment'. Looks pretty good .. could do with more epoxy around the base of the rivet though. Please PM your address and I will send you a repair kit Nige. [ Guests cannot view attachments ]
Ash
JamesH:
Ash you're a legend...
Green1:
+1 Looks great Ash. :)
Mick
AshimotoK0:
OK ..I know you think I am crazy but I did some more evaluation. Please don't mock me it's just my nature to fanny about like this .. done it since I was a sprog!
1st I topped up the epoxy, cured overnight on the top of my boiler, then I hooked the pin up to a small chuck and linked to a load cell/data logger. In one test I applied 21 kG and the badge was creaking a bit so I backed off. I then recorded a test and at 16kg the chuck pulled off the rivet but the bonded rivet was still intact. So looks like result!
Ash
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version