SOHC.co.uk Forums > CB350/400

Spoked Up

<< < (3/4) > >>

paul G:

--- Quote from: Lynx on April 05, 2015, 09:06:15 PM ---Cam caps and covers are often low torque. I have a 1/4" drive torque wrench on my wish list for that reason .

--- End quote ---
Trigger somebody must have been selling it for less than a pound and you could not resist it ;)

Lynx:
I want a 1/4" drive torque wrench ::).

Lynx:
OK What's the secret to fitting tubed motorcycle tyres? I can fit tubed bicycle tyres fine. I can fit tubeless motorcycle tyres fine, but I have just tried fitting my NEW inner tube and tyre three times this afternoon and punctured it each time  :'( :'( :'(.

paul G:
Lynx,

Put a bit of air in the tube so it is not flat and it pulls away from the wall.
Not too much just a tad and it allows you to get the levers under it without trapping it.
Three holes in the tube throw it away and start a fresh.

Lynx:
5 holes actually :-[. I'll take it to the bike shop tomorrow.

Navigation

[0] Message Index

[#] Next page

[*] Previous page