SOHC.co.uk Forums > CB350/400

Carbs

(1/3) > >>

Dundrod:
Need help with my carbs set up as it seems to be all over the place I am running pod filters with a Mizuno / Yoshi rep exhaust DS electronic ignition standard jets float heights and needle height so far air screws out 2.5 turns I can get the carbs balanced nicely then give it a rev and the revs take off alternatively she will struggle to start fart and backfire was thinking of jetting up anybody know anywhere in the uk that does jets I replaced all the carb jets seals etc with new kit from Cruzin Image seals and O rings replaced from Holland and carbs were ultra sonic cleaned thanks in advance for any advice its doing my head in  :o

Bryanj:
Sirius in Canada(http://www.siriusconinc.com/pro-detail.php?pid=&product_id=176) do a jet "Kit" with several different sizes of mains. What size are yours as 500 ones might be a bit bigger and I have a few of those somewhere

Dundrod:
Thanks for the reply Bryan the stock size is 75 for the main jet if you have any that may help I will buy them from you thanks

Norniron:
Im running with pods,yoshi and dyna ignition on my 400.
I increased the main jets to 85 and as yet have no problems.
500 jets are 100 and may cause her to run too rich

Dundrod:
Thanks Norn Ive a set of jewellers drill bits and the jets I replaced will try gong up in .05 mm increments just to see, where did you get your 85 jets?

Navigation

[0] Message Index

[#] Next page