SOHC.co.uk Forums > CB750
Disc Grinding
Graeme77:
I know a couple of places in sheffield who could do it. The kind of places youd be best off poping down to though. Id guess they would charge something around £40 going by what they charged to do my lathes spindle.
Trigger:
--- Quote from: AshimotoK0 on April 15, 2015, 10:03:31 AM ---
--- Quote from: Trigger on April 15, 2015, 08:44:27 AM ---Have always used a disc cutter in the past, it cuts from both sides at the same time so, it is kept true. Have seen people cut them on a lathe before but, a surface grinder should work if the disc is not in bad condition.
--- End quote ---
Do you know a company who can quote me on doing it Graham?
Ash
--- End quote ---
Must be somewhere local to you Ash ;)
AshimotoK0:
We have a large lapping machine here but I would have to separate the disc from the carrier to use this. Vic World evidently separates the two but how much of a job is it to re-rivet back together again safely?
[ Guests cannot view attachments ]
Bryanj:
Used to sell/buy cast iron discs that came with a set of bolts and nyloc nuts but that would not look original although engineering wise a perfect sollution
Navigation
[0] Message Index
[*] Previous page
Go to full version