SOHC.co.uk Forums > Project Board
CB750 F1 Project May 15
Coppertop1234:
Seat base completed
Quick question
The holes in the base unit, I would presume are for drainage of any moisture absorbed by the foam.
The foam looks grotty where the holes are, so I thought of placing some of that black rubber anti slip stuff you put under doormats.This should allow moisture to escape and improve the visual look when you lift the seat.
It would be a shame to replace all the foam just for the parts where the holes are as it is in excellent
condition
a few pics of finished product
Green1:
Looks good I always thought the holes were to let air escape from under the cover when the foam is compressed when hitting bumps.
Mick
UK Pete:
That seat base looks real good, i have read somewhere that you have to anneal the metal tabs/spikes so as they dont snap off when re-bending, however i have done a couple of seats without and all was good
pete
mike the bike:
The holes are to let the air escape when you sit on it.
Coppertop1234:
Front brake is still sticking
new master cylinder kit
new braided hoses
new piston & seal fitted all movement seems ok
rear retaining arm has free movement on forks
new bolt tension bolt and spring
new pads - pattern could it be they are too thick?
Apply brakes and they don't want to release enough to free spin the wheel
Unless I am missing something ? they should be ok
I have put it down to a senior moment and will have a look later unless there is a something obvious I am missing
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version