SOHC.co.uk Forums > Project Board
CB750 F1 Project May 15
yozzer74:
Does the bottom cup have to fit up to the lip or is there a little gap .?? Hard to see in the picture .when I did mine I couldn't get it to meet the lip so there's a little gap I have wounded if it was ok .it all went together ok .
Spitfire:
It does look like there is a gap there, if I remember rightly the shoulder that it goes up against isn't square so it looks like there is a gap, but I've never had any bother with it and the bikes been back on the road for quite a few years now. I just tapped in as far as it would go keeping it square.
Cheers
Dennis
Coppertop1234:
Head bearings fitted with thanks to all for the info/ links provided
The hackaweek tool for removing the bottom race worked a treat, as did the threaded bar for pressing new bearings in.
Yippee the old girl now steers round corners without all the crunching and stepping out of the steering.
Next project while we wait for the front wheel to come back from re chroming
We found an original exhaust that is practically unmarked and been dry stored - So the old one is for project 2 (Yellow)and the new for my project 1 (Red)
We also have a spare original exhaust that is in need re chroming, we have repaired it and its quite solid so should be ok as a spare should we need one in future years
Coppertop1234:
Just fitting the stickers to the F1's from Piki and 1 has me lost as where it is located.
The silver exhaust modification sticker - I didn't have one on the bike, so no reference point to work from.
Advice please if anyone can help out?
Spitfire:
According to the parts manual I'm pretty sure that it supposed to go on the top of the swinging arm by the rear brake cylinder, mine did not originally have one, but as it came with the kit I stuck it on.
Cheers
Dennis
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version