SOHC.co.uk Forums > CB750

Top yoke D Washers

(1/3) > >>

philward:
I know these D washers have been discussed on several posts before but has no one made any from dimensions off the originals? I was just going to order 2 from DS but £6 each! (so £15 posted in total). I made some up from washers for the later yokes I had on to accomadate the repo clocks, but now that I have got the original rhino horn top yoke on, don't want to risk a yoke breakage.
Anybody got any or dimensions?
Phil

Trigger:

--- Quote from: philward on July 12, 2015, 08:50:30 PM ---I know these D washers have been discussed on several posts before but has no one made any from dimensions off the originals? I was just going to order 2 from DS but £6 each! (so £15 posted in total). I made some up from washers for the later yokes I had on to accomadate the repo clocks, but now that I have got the original rhino horn top yoke on, don't want to risk a yoke breakage.
Anybody got any or dimensions?
Phil

--- End quote ---

Here you go : 16mm OD, 8mm ID, 2.3mm thick and the cut away is to 14mm  ;)

philward:
Cheers Graham - l'll have go at making a pair

Trigger:

--- Quote from: philward on July 12, 2015, 10:06:23 PM ---Cheers Graham - l'll have go at making a pair

--- End quote ---

Made a few in my time  ;D
The last one's were made from manifold spacers at ID 8.5, OD 15.5 and 3mm thick. Took them down to 2.4 mm but, you may find some better size ones with a look about.

AshimotoK0:
I just measured one that's been stripped of its original coating and it measures 2.3 mm thick

Navigation

[0] Message Index

[#] Next page