SOHC.co.uk Forums > CB350/400

Horn mounting clip

<< < (2/3) > >>

Chris400F:
I have just looked at the diagram in the setup manual again and now I am confused, as it shows the clip mounted to the front bolt.
As a 9000 mile bike I don't know that it would ever have been apart, but that doesn't mean it was 'right' in the first place.
Without taking the tank off I can't have a better look I'm afraid, although I'm sure it will do the job intended whichever bolt it is mounted to.
As previously noted, the clip holds the throttle cables and clutch cable in place, not the tacho.

Myford:
I had it on the rear bolt to start with, but reading an old topic titled Coils/leads (sorry can't do the clever link) it suggested to me that the clip included the tacho cable, that's what was driving me potty trying to figure  out how it could possibly hold the tacho cable.
Thanks for the help guys. now for my next topic  ....... coils.
Terry

tom400f:
OK so it's the front bolt and mine is, amazingly, wrong but I have removed it before so my fault.

Another 400F discussion on forensic detail  ::)

steven400/4:
front bolt offside of the bike throttle cables but i,ve never had taco cable in it before just in the ring on the breather its the same on all four of my bikes

tom400f:
That's the clutch cable Steve  ;)

Anyway, glad I didn't mislay the clip. Heard they are a fortune to replace  8)

Navigation

[0] Message Index

[#] Next page

[*] Previous page