SOHC.co.uk Forums > CB350/400

400/4 Exhaust

<< < (5/8) > >>

Saisei:
Hi Ash, I am thinking of going to Cadwell on Sunday, might be able to kill two birds with one stone?

AshimotoK0:
Sorry Dave .. away most of weekend probably best to send.

Ash

Saisei:
It looks like I will have to miss Cadwell this weekend anyway. I can come down when it is convenient to you.

Cheers

Dave

AshimotoK0:
Had fun and games checking the Saisei pipes with a NOS Honda silencer. I can get it all to fit but only after slackening the header clamps then inserting the two silencer to frame bolts ('75 bike no bracket), Then gradually tightening everything up . There is a gap about 8mm  between the collector and the sump. Not sure on the fit of the slencer to header junction though. Does this look correct? Not sure if the collar welded to the collector pipe should be in engagement with the clamp on the silencer or not. Bloody freezing in the garage and the 400/4 is rammed into my garage with an MG Midget stopping me from getting really good access. off for a beer ;D ;D

[ Guests cannot view attachments ]

[ Guests cannot view attachments ] .

AshimotoK0:
Anyone?

I need to get these off my bike and back to Saisei ASAP... I am only doing this for the benefit of other members / David @ Saisei, owning  400's, as I have the NOS original Honda pipes on my bike, so not really of any use to me other than anorak fodder.

Perhaps if I remove the headers and make measurements from the two fixed header pipes to a specific point on the output pipe that may reveal any differences. Or does anybody have any other suggestions please?

Cheers  ... Ash

Navigation

[0] Message Index

[#] Next page

[*] Previous page