SOHC.co.uk Forums > Project Board
Rickman build
captaink:
I'll give them a check over then
The head is going off for new guides and valves complete tomorrow
And the cases are already into the vapour blasters workshop after which I'm sending them up to have new APE studs fitted and a visual check over.
There going to sort out new pistons and rings.
I was advised that the gearbox bearings don't usually wear except one but might change all anyway as I get them trade cost.
I'm away for a couple of weeks, when I come back hopefully some parts will be ready
AshimotoK0:
Some bearings are grooved. Which ones do you use is it the C3 high speed type?
captaink:
No idea yet but as each bearing has a number it won't be a problem
I only use top bearings no cheapies
Bryanj:
The gearbox bearings WILL be a problem as the grooves are not a standard size so "Normal" bearings to number won't fit
AshimotoK0:
Yamiya are a good source for those bearings with grooves (e.g. CB750K0 output shaft bearing) or location holes round the outer shell. What would you use for those that look 'standard' Bryan, would it be C3 rating? and which manufacturer?
Ash
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version