SOHC.co.uk Forums > Project Board
CR 750 for road use build
CR21:
Great post! Check out Lordmoonpie exhaust pipes!
Cheers,
CR21
philward:
Heres the link - http://www.moonpie.co.uk/html/cr750_resource_page.html
The next stage of my build is making my set fit - they are not bolt on. You will need (like me) to fabricate baffles as they are straight through and will struggle to pass an MOT! DB killers may do but will only knock a few decibels off.
Phil
captaink:
Been having a few issues in my head with the crankcase numbers/ crankshaft numbers / bearing colours / journal sizes but seem to have got there in the end although for some reason or not the oil clearances are higher than the manuals say :-[
My engine man doing the rebores etc says not.....confused dot.com. :o
anyway now I'm looking at journals and oil clearances that are at least consistent but I need Black shells to achieve this and I believe there within the limits
Plastigauge confirms the following clearance
Main bearings between 0.038mm - 0.040mm :D
Rod bearings 3 @ 0.040mm and 1 @ 0.043mm :D
captaink:
No disrespect but what is the quality like of the moonpie exhausts, are the bends consistent and nicely done.
I'm a fussy git, perhaps too fussy.
Has anyone fitted a set and what is there honest opinion.
SteveD CB500K0:
Simon Tappin (LordMoonPie) is a member her http://www.sohc.co.uk/index.php?action=profile;u=313
He hasn't been online for over three years, but I'm sure he'd appreciate a call
Steve
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version