SOHC.co.uk Forums > CB350/400

52141-369-000 Swing arm rear centre collar

(1/4) > >>

Mr-Gear:
Hi all,

I appear to be missing this part from my build. which could explain a slightly snatchy back wheel before the rebuild. I bought some of the brass replacements from germany but realised this part was missing!

I'm going round all the usual places to find a replacement of this part, however - if anyone has this item, could they be kind enough to post a few pictures and dimensions so that I may fabricate this part if I cannot source it?

Thanks, Ryan.

Bryanj:
If that was missing there would be so much play on the back wheel it would have been unridable never mind snatchy!! What bike is it for?

Dave_Canada:
Yes, rather vital - and "scratchy" doesn't describe one missing.
Have a look in the swingarm, you'll probably find it in there stuck hard to the pivot bushings. This is not unusual: the bushings, left unlubricated, corrode onto the collar and then the swingarm pivots (poorly) on the bolt.
The collar is NLA, and no aftermarket suppliers are known to me. This part is used on 360 twins, some other twins, the 350 Four, and the 400F. Possibly others. "366" is the CB360 model code.

Green1:
The one on my 750 had a small grove worn into it from lack of maintenance and made the bike wonder all over the road.
Worth greasing every couple thousand miles.

Mick   

Mr-Gear:
The bike is a CB400F

Hmm, Strange. When I said it was slightly snatchy it was an understatement  :P I can't find this part in my frame bits box and I really don't recall removing it when I took the swing arm out and cut the collars out - although the pivot bolt was very tight. Maybe I'm wrong - my memory isn't terribly accurate!

Either way I'll need to replace it so if anyone could measure theirs I'd be awfully grateful!

Thanks, Ryan

Navigation

[0] Message Index

[#] Next page