SOHC.co.uk Forums > CB350/400

Boyer Bransden ignition system first report.

<< < (2/2)

K2-K6:
As far as I understand it, you just have to be in excess of the maximum advance point.

Higher revs than needed are not going to give you any error as it'll just stay at a fixed maximum.

So, if you set it at 4,500rpm, then run it up to 6,000 it shouldn't change at all as should have already peaked lower.  If that makes sense.

They are just setting a maximum absolute advance point to avoid going too far at redline. Anything underneath that is determined in their programmed strategy.

Navigation

[0] Message Index

[*] Previous page