SOHC.co.uk Forums > CB350/400

Front and rear wheel spacers (collars) CB400F

(1/3) > >>

beemsquar:
Does anyone know the dimensions for the front wheel spacer and the two rear wheel spacers?

I don't think I have the right ones on my bike as the rear wheel doesn't fit in the swingarm. The bike came with a different set of wheels and when I a combination of those spacers it fits and the alignment is correct.

If I can get the correct dimensions I will get some stainless steel ones made up.

Cheers

Rirons:
I have just stripped mine down I'll measure them for you and post the results it will be tomorrow I'm enjoying a beer now  :)

Chris400F:
I had dug out a G5 front hub I have (same as the 400, spacer has same P/N) before I saw Rirons post so I've measured the spacer from that anyway.
O/D 22.0 mm
I/D 15.1 mm
Length 17.0 mm
There is a chamfer on the inner edge at each end as shown in the photo, not sure how vital it is.

[ Guests cannot view attachments ]

hairygit:
The chamfer is there to stop people injuring themselves when handling it, and it also makes putting the spindle in marginally easier as there is a tiny amount of leeway to insert it, so quite important really!.

Rirons:
Just measured the spacers

Rear wheel drum side 30 x 18 x 30long
Sprocket side 30 x 18 x 33 long
It easy to mix them up as I did it but it obvious when you look at the sprocket alignment not sure if you can get them from DS if not I'm going to draw them it and make some SS ones

Front has a 22 x 15 x 17 long plus a flanged bearing bush which I'm just drawing up at work as this is unobtainium I'll post the drawing when done

For info my wheels are spoked

Let's me know if you need anything else as I have it all broken down while I respoke and clean the grotty hubs

Navigation

[0] Message Index

[#] Next page