SOHC.co.uk Forums > CB350/400

Front and rear wheel spacers (collars) CB400F

<< < (2/3) > >>

beemsquar:
Cheers guys very helpful. Well that explains why I couldn't get the rear wheel in then.

Both my rear spacers measure 30x18x33 long, that 3mm makes all the difference! the one I used off the other set of wheels is 29mm long.

I'll get some made up in stainless I think.

Thanks again!

exvalvesetdabbler:
The one from the rear sprocket side will have a shiny band where the rubber seal has been rubbing on it.  The other side shouldn't have.

If you still need confirmation of collar lengths, I can have a rummage in junk boxes over the weekend, should still have the originals somewhere as I never throw anything away. My current ones were machined from a lump of 316 stainless.

Also if I remember right one, of the rear bushes has a center groove, probably as a marker so the factory knew which one was which.

Regards
Dave

beemsquar:
If you could have a look that would be great,  I would rather have more info, plus it might help someone else out too.

How much did it cost to get them made up in stainless?

exvalvesetdabbler:
Ok I will have a look when I'm home at the weekend.

The new spacers, I made them myself using a small model making lathe.

Regards
Dave

exvalvesetdabbler:
[ Guests cannot view attachments ]

Sprocket side  29.6mm
Brake Side 33.7mm

Both 30 mm diameter with through hole to clear 17mm axle

Regards
Dave

Navigation

[0] Message Index

[#] Next page

[*] Previous page