SOHC.co.uk Forums > Project Board

1971 CB500K0 Resto 3/71 VIN 1000896

<< < (54/54)

Bryanj:
Is that where that little oil feed press steel bit fits Ash?

AshimotoK0:

--- Quote from: Bryanj on April 05, 2020, 02:26:25 PM ---Is that where that little oil feed press steel bit fits Ash?

--- End quote ---

Possibly Bryan.. I think I might need to take you up on those upgrade parts if you have any of them,  once all of this nightmare is over mate. Jason found me the little plate but talking to Trigger, every early K0 he's come across for an engine rebuild had those upgrade parts fitted and he he fitted them to the UK one he restored.

I hope I didn't come over as ungrateful when you first offered them .. it's just that I feared for your families health going on an trip to your lock-up on my behalf. I can assemble most of my engine without the clutch for the time being anyway. I will just make sure the screw in my shift drum is free, as part of the upgrade is to replace the shifter plate and pins.. Oodles of other projects to get on with anyway.

Bryanj:
Ash, give me a bit of time to sort it all, you can build all the rest of the engine except clutch etc as the mod was done in situ.

Navigation

[0] Message Index

[*] Previous page