SOHC.co.uk Forums > Project Board
1971 CB500K0 Resto 3/71 VIN 1000896
mickwinf:
I believe that the original stanchions were only chromed on the area below the bottom yokes as the rest is covered by the headlamp brackets, mine stayed rusty!
AshimotoK0:
Made this rusty bad boy after work today to try to remove rear hub bearing retainer. A quick clockwise tug did nothing but need to have a proper go tomorrow. Bolts are specials from a Kwak Z900 ...hows that for extravagance ;D.
Read on the US site that you can hot tank the hub in the Ultrasonic cleaner to remove internal corrosion. Worth a try before I fk it up,
[ Guests cannot view attachments ]
UK Pete:
Nice work ash, was that the kitchen worktop you have your exhuast on LOL
if your keeping the cost down then i would just treat the rust fork area if its no more than surface pitting
Keep up the good work
pete
AshimotoK0:
--- Quote from: UK Pete on December 08, 2015, 10:12:35 PM ---Nice work ash, was that the kitchen worktop you have your exhuast on LOL
if your keeping the cost down then i would just treat the rust fork area if its no more than surface pitting
Keep up the good work
pete
--- End quote ---
Wife was out :) If she's in Am Dram 'play' mode she'd probably not even notice it anyway. .... its sqeaky clean now anyway since I washed it in the parts washer then bead blasted it.
UK Pete:
Liking your style ash
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version