SOHC.co.uk Forums > Recommended Sources for Parts and Services

CB500 bolt sets?

<< < (4/5) > >>

royhall:
Ash. Just checking before I buy the wrong thing again. Is this t-bar the correct head for the Genuine Honda casing screws.   

http://www.ebay.co.uk/itm/philips-screwdriver-t-bar-vessel-no-3-phillips-japanese-made-/321950795893?hash=item4af5c34875:g:I1YAAOSwmrlUvOf2   

Cheers.

AshimotoK0:

--- Quote from: royhall on January 01, 2016, 11:14:57 AM ---Ash. Just checking before I buy the wrong thing again. Is this t-bar the correct head for the Genuine Honda casing screws.   

http://www.ebay.co.uk/itm/philips-screwdriver-t-bar-vessel-no-3-phillips-japanese-made-/321950795893?hash=item4af5c34875:g:I1YAAOSwmrlUvOf2   

Cheers.

--- End quote ---

I think it will be Roy because it's made in Japan. But I would ask the question just be sure. When I looked at the impact driver I got it's available with both JIS or Philips type bits, so as Bryan says you have to be careful.

http://www.vesseltools.com/hand-tools/screwdrivers/jis-japanese-industrial-standard/view-all-products.html

Chris400F:
Excellent link to JIS information Ash - thanks for that. But where do you get them?
My impact driver takes 8mm hex bits so I would want Vessel set 431801.
I have contacted them to ask about delivery to the UK but another forum suggested their charges were a bit on the steep side.
I found a set of Vessel JIS/ISO bits on eBay but they are 1/4" hex fitting.
So, any suggestions for alternative suppliers of Vessel stuff.
Alternatively any suggestions for an impact driver ('hit with hammer' type) that takes 1/4" bits.

royhall:
Got one ordered Ash should be here tomorrow. Will let you know how it fits. Cheers.

Sent from my Nexus 6 using Tapatalk

royhall:
T-bar screwdriver has arrived and it fits the standard case screws perfectly. Thanks for the nod on that one Ash, it will be very useful.

Navigation

[0] Message Index

[#] Next page

[*] Previous page