SOHC.co.uk Forums > CB500/550

Primary Chain + F1 forks

<< < (3/5) > >>

Bryanj:
Don't. think the wheel spindle works on a 500 but it shouldn't cost much for a dealer to do it if you take in just the crank. The Honda tool is about £35-40 as I remember so you need to have a few to work on to make it worthwhile

Chris400F:
Is this any use?
http://www.ebay.co.uk/itm/Honda-CB500-CB550-CB650-SOHC-Four-1970s-Alternator-Rotor-Puller-Tool-16mm-/251966261335?hash=item3aaa5c0857:g:q0UAAOxydlFS-TpM

Seabeowner:
Just my luck.
Lower rear engine mounting 12mm. Ideal for using as slide hammer to withdraw primary shaft.
Swinging arm is 14mm
Rear axle is 18mm
Nothing on bike 16mm that I can fid.
And to cap it all. Yes I was looking at the tool on ebay but thought the 4-way device would be a better investment. David Silver sell an aftermarket one for about £25. It has been OOS for a while and I got fed up with waiting and ordered a load of stuff from him on Monday and did not bother to put it on back order as I thought I could not wait.  Stuff arrived Wednesday and yesterday they tell me the tool is back in stock and they charge £5.85+Vat for dely!!

Bryanj:
You wana bring it to Gloucester i'll take it off for nowt!!

Seabeowner:
Thanks Bryan, but a little far. I'll get the DS tool. At least it will have a re-selling value.

Navigation

[0] Message Index

[#] Next page

[*] Previous page